Katfish's latest activity
-
Katfish replied to the thread TV cable with DBW throttle body.I did something similar to this for my 518, but I'm using the MP controller -
Katfish replied to the thread 4 GATE ADAPTER SLAP STICK.3.73 gears, 275/40/18 (26.7 diameter) rear tire
-
Katfish replied to the thread 4 GATE ADAPTER SLAP STICK.I have a 518 behind my 5.7. It's an absolute joy to drive now, no more putting around in the slow lane as minivans pass by...
-
Katfish replied to the thread K Frame number.Coin is last 2 digits of PN, 72 doesn't show up for 70-71, so must be a later year K FRAME COIN
-
Katfish replied to the thread New from Switzerland.Nice! Looking good, how does she run?
-
Katfish replied to the thread Lower Control arm bushing.method using a tap
-
Katfish replied to the thread Lower Control arm bushing.Plenty of YouTube videos, 3 options - buy the speciality tool - cut a slot down the side and chisel it out - weld a washer on the end...
-
1/4" spacer on each mount and a little trim to the stud and we have clearance. I wish I had waited to order the manifolds, they have the...
-
Katfish replied to the thread Front Disc brake assembly.This? Mopar 66-72 Disc & Drum Brake Spindle to Backing Plate Gasket
-
Katfish nailed it! People run out and buy expensive torque convertors all the time when building big torque motors when they could have...
-
Katfish replied to the thread Torque converter stall speed.I would go with what you have, unless as mentioned, the cam puts you into another RPM range Torque Stall K 425 2500 121.27...
-
Katfish replied to the thread Torque converter stall speed.I don't think the TC will affect the vacuum. Numbers below are probably closer to what you're starting with and heading to. Factory...
-
Katfish replied to the thread Torque converter stall speed.Set up a spreadsheet and see where it falls. You might be ok with what you have, since the only variable is the increased torque...
