I am replacing my power steering gear box in my 70 Challenger and the original round case is machined flat where it is near the lower control arm (to provide clearance I assume).
The replacement is not and the clearance is only about 1/8" at normal ride height.
I assume this will not be...
Beware recent scam activity related to parts wanted post.
I received a PM from a member that someone had the part that I’m looking for, with the following contact info and paypal ID. Member Smithson67 had recently joined and is now gone along with any record of his PM to me.
They requested...
I am hoping to do a rust repair to a square foot section of the stock floor pan on my 70 Challenger. I need the middle section of the passenger side, below the bucket seat, in between the foot wells.
I have a 70 Challenger that has had a section cut from it's torsion bar crossmember from above the trans to between the mounting holes for the trans crossmember on the driver's side, so am looking for something with that part that is good.
My 70 Challenger has had the floor pan brace cut to clear the a833 speed trans shifter linkages, leaving the trans crossmember secured with 3 of 4 bolts. I can't believe this is correct but have not found anything in the parts or repair manuals showing the trans installed. Can anyone point me to...
I am in the planning stage of putting my 70 SE back together and see that the low profile belt molding has dents at each clip location coming up from below.
My old clips have a sharp edge sticking up and is not far from contacting the trim. I assume a little pressure down on the trim after...
Greetings from North Idaho. I've had my 70 for years and looks like I will now have time to continue it's restoration. JS29 VIN with 383 and 4 speed A833.
Looks like a lot of good info here.