These are the over the counter carbs (Direct Connection)that places like Mr. NORMS would install. They are mechanical and I had a vacuum setup also.
I prefer the mechanical ones so I sold the vacuum setup.
The only reason I’m letting these go is I have a fresh 418 with a tunnel ram going in...
I have a 1970 340 engine with 680 miles on it since being rebuilt. This was professionally built by a well-known stock/super stock NHRA builder.
It is a solid roller cam with Harland Sharp rockers. The one and ONLY issue with this engine is we made the decision (which I regret now) to not bush...
I have a nice center section that was rebuilt and ran in a big block b body car for 12 1/4 mile runs.
It is a 741 case, cone-type sure grip. Small u-joint
Speedmaster shipping container included ( 60.00 from Speedmaster) which measures 20"x14"x13" approx. weight is 75 lbs. for shipping quotes...
I have a nice 489 case 3.23:1 dated 1972 cone-type sure-grip center section for sale. I have been running this in my car for the last several years with zero issues. The only reason I'm selling it is I've decided to stick with the 3.55's I have.
I am listing the adjustable pinion snubber...
I have a very nice complete small block six-pack setup for sale.
The carbs have been rebuilt, including new diaphragms.
The fuel lines and linkage are complete.
I have a spring kit for the vacuum pods. I did save all the old components for the carbs that were replaced.
This includes the air...
I have a NIB small block Mopar Performance solid lifter cam and lifters kit for sale.
Purple shaft P/N P4529973
Specs are in the photos.
Asking 425 shipped in cont. U.S. from 80534. Will ship outside the U.S. for difference of actual shipping cost.
I have a standard bore, 1970 340 block for sale. It’s been sitting in storage for many years.
VIN # 1B113346 according to a member here, it’s from a ‘71 Cuda.
I sprayed it with LPS3 when I got it. It’s dirty from sitting.I would think it will clean up fine at .030
The main caps are with it. I...
I have a nice set of hood emblems which I believe are for a 1970-73 Challenger.
P/N 3443246
No pitting
The paint is worn some, more on the lower emblem but no to bad.
The pins are all in good condition.
Asking 80.00 plus shipping from 80534