Search results for query: *

Ok thanks

I will try that. I just ran that rear new harness. A couple of days ago... I also installed the new turn signal, switch on Friday.Had to swap the 2 yellow wires on the current switch.I am using.\nYeah , the turn signals working didn't check the brake lights until today.... Also have new wiring...

I was thinking the same thing I swapped the bulb with a new one. Still the same thing, the parking lights work. Both sides, the turn signals work both sides. When I push on the brake, the passenger side works driver side does not But Driver side front turn signal lights up when the break is pushed.

Can anyone tell me how my wiring should go? As far as the plug with what I have in the pictures, thanks\n Sorry for the confusion. I'm just not that good at figuring things out like that. I thought I had it LOL

This is the switch that I used... One picture shows the current color of the wires... The other picture shows that I just swapped the yellow wire.. I thought I had it until I tried the brake lights passenger side.Brake light works driver side front turn signal light comes on with the break...

LOLI have a new issue.Wish I was good at reading schematics.. the park lights work. The turn signals work, but for some reason when I push on the brake.I have a passenger side brake light.No driver side brake light, but I do have a light on the driver's side.For the turn signal comes on with...

Cool thanks

Thank you.....

Is there a diagram or any pictures that shows the routing of the rear wiring harness after you plug it in UP front?And it runs down and up into the trunk... After it enters the trunk , which way does it go.. I know it seems obvious, but LOL.. Were there originally metal bendy strips that held...

I had to switch a couple of wires around on the doing this , which I just purchased everything works as it should....

So when installing the bumper guards , the bracket , that goes on the bumper guard and then to the end of the frame between the shackles... Are you supposed to put the bumper guard filler piece on and then put the bracket on the stud , tighten it down and then put the bolts in it through the...

I believe you are right.We were probably here before this is what I have now... I do not have the original plug.This was in the column when I got it.. If I take and get those plns out and put them into the plug according to the mopar, turn signal wiring diagram.You have above.isthat at all I...

On my seventy three barracuda , with a rally dash.. Passenger side turn signal and hazard works.Driver side does not... I have no power coming from the turn signal harness from the - on the white wire that I believe feeds the left turn signal. It turns into a light green wire, and the turn...

That would definitely work.What did they come from

Ty

Where do the square reinforcement plates mount too..

The wiring harness that I am using for my 73 barracuda, needs to have the turn signal socket. Pigtail, that has the flat rubber plug with round terminals. If anyone knows where to get that, I would appreciate it, this is what I am working with.I believe it is the turn signal plug...thanks..

Not yet

I decided to go this route.I do have the bolts.If I wanna change , we'll see what happens...

Thanks