Search results for query: *

What is wrong with your canister? You can rebuild them. Get some activated charcoal from the pet store (used for aquariums). You will also need a piece of filter material.

Bump....someone has to have these.

Yes, send me a PM.

Here are some pictures. Be aware it has cosmoline on it, thats not rust. Length is about 27.5"

Likely so. I heard they wanted a small fortune for the rights on them. I was lucky to get some from B&E right at the end before he ran out.

Yeah I will dig it up after work tomorrow (its 2 am here right now). It may be coated in cosmoline for storage....cant remember. It came out of a good trans, swapped the shaft and tail housing to convert it for my swinger.

Im working on two 74 cudas and only have one of the qtr window upstops. So im looking for three of them. Here is a picture, I only need the piece that screws on the brackets and the hardware if you have it. May be the same on challenger but not sure.

I just converted an E body trans to A body and have a good mainshaft available.

Thank you for the input, I think I have what I need. Appreciate the help.

Is that measurment from the top of the filler neck or the tank?

The case appears to be sandblasted but I dont see anything to suspect the numbers were restamped. I have a half dozen four speeds here and the numbers are all over the place like that one.

Im in the process of custom fitting an aluminum radiator in my 71 cuda. The radiator bolted in fine but needs to be raised up quite a bit to use the factory shroud. So im looking for a measurement from the top of the radiator support to the top of the filler neck. I measured with the factory...

I responded to your PM. I already cut that jig up since I finished the front of the car.

I wonder if that affects the handling any. With the USCT spring relocation are they parallel or do they retain the splay in the rear? I have already welded in the front spring buckets and notched the frame rails. Widening the wheel tubs next then will do the rear spring hangers. Im thinking of...

Thanks, that confirms what I though. It appears to stick up above the support. If someone can get me a measurement that would be great.

Im installing an aftermarket aluminum radiator. Its going to require some customization on the mounting brackets but I need to know how much higher does the top tank sit above the radiator support. As I have it installed now the shroud cannot be installed because the fan will hit it. Looks like...

Im getting ready to relocate my leaf springs and im mocking up the stock suspension to check everything since I replaced the rear rails. I know the frame rails splay outwards, but do the springs as well? Im showing the springs 2.5" wider at the rear. Can anyone get a measurment of the leaf...

Nope

I pulled the seats today as I was also curious if I could be lucky enough to find a build sheet. Yes I found one! Well, a 1" x 1" piece of it.

Thank you for confirming. Yes I agree, they are quite ugly. Im cloning a 74 into a 71 but think I will be sticking to 72 seats since I already have covers on order.