Search results for query: *

Today students have the driveshaft installed however when you shift the transmission into 1st the yoke hits the shift shaft. My guess is the shaft is about 1 inch too long. Todays lesson was bleeding hydraulic circuits. The Seniors were bleeding the clutch and the junior class bleed the...

There is a gentleman near me with 3.23 and suregrip. Spoke to the students today to get their input. Are you saying these 2 wont have much of a difference?

Is LSD desirable?

where could one source a 3.23 suregrip?

I wasn't going to suggest the spoiler. lol

TREMEC TKX 5 speed for FORD/MOPAR. 600 torque, 26 spline input shaft. Wide ratio 3.27 1.98 1.34 1.00 .72, REV.D

So I spoke with Tremec about the transmission being 5 speed and they asked what our rear gear was and they sold us the trans that would be best with that gear ratio. So will this set up with 2.76 be undriveable?

I do owe some thanks to the previous instructor I took over for because he set it up. Ran for 18 or so years then I took over in 2020! Past students do actually come back to meetings and they help with tickets and shows! As for a forum, this new day and age we are lucky they answer a phone...

not selling. Raffling off. we will sell tickets for it!

Tickets start in February!

So far! Even better we raffle it off when it’s done!

I teach an automotive class in high school based out of Syracuse NY. This year we are building a 1972 Plymouth Barracuda. We do have the build sheet but we did not have the matching motor. This is a custom build. Here are some specs. Are they desirable? Engine: 2018 Challenger RT 392 HEMI...