Search results for query: *

Are these in mint condition?

I can take it off your hands if you can ship it to Sweden :) How much would that be? Will you take PayPal for shipping costs? I will cover the fees of course.

PM sent

Here are the highest quality gauge decals you are likely to find. Compared to most decals you find online these actually place the letters at the exact same spot as the original face and have sharp edges on the details. These decals are metric speedometer only. If the need for a miles should...

Thanks for your reply! That's what that was, the reverse light wire. Thanks! Doing another trace and I found that the black wire with yellow tracer on the MP electronic ignition module terminal is hooked up to the coils negative. The two looks almost the same. What is strange is that doing a...

Thanks for the replies guys! No offense to you that replied, but I basically knew what to do, I'm not cutting the oil lamp wire as it is possible to back the terminal out and just connect it to a female spade terminal with a round connector in the other end. But anyways, can I just disconnect...

Hi, I started converting my 70 Cuda to Rallye gauges today and I found a wire that I don't know what it was for. As it is now, it is hooked up to the minus side on the coil. I traced the wire under the dash and I think it ends up at the headlight switch? The resistance when I checked was a bit...

PM sent.

What are you talking about? I only asked about a driver side parking light and you PM me asking $900 for the grille and parking lights. Not a bad price at all, but I never asked for the grille. I NEVER asked about any intakes.

Hi, Assuming it is not cracked and in good condition, how much do you want for the drivers side parking light? How much for the 4-speed console?

Excellent! Glad to hear you got it running as it should!

You should NEVER have the negative battery cable connected when you are working on your car! It is so easy to make a short somewhere that can fry your wiring and in worse case, cause a fire. That should be the last thing to reconnect when you are ready to fire it up and start to measure...

Take the multi meter and measure the resistance from battery plus to alternator output stud (with the negative battery side disconnected). It should have a very low resistance like 0.05 ohms. Also measure the resistance on the wires going from regulator to alternator. Corroded terminals will...

Take your multi meter and measure the resistance from the alternator stud to the battery + (with the negative post unconnected). Do the same with the two wires going from the regulator to the alternator. You should have a very low resistance of something like 0.05 ohms. If you have more than...

The fusible link is the only fuse on the main power circuit. It will unfortunately not protect you from a short on the alternator side. The problem may be a short under the dash or a corroded terminal at the bulkhead. Hope that helps! Per

Have you fixed it? The alternator can output 19 volts if something goes terribly wrong! 14 volts is perfect! Anything above 15 is dangerous! What is your voltage at the battery, when it is 14 at the alternator battery wire? There should be no more than 0.1-0.3 volts less at the battery if...

Where do you measure the 10-14 volts? At the battery or at the alternator? If you measure 10 volts over the battery, I would replace that!

Have you solved it? A faulty voltage regulator will result in no charge. Make sure you have good ground on regulator and alternator. Per