Search results for query: *

Wanted steering column key light.

I did use semi-metallic Raybestos pads, you might have it moparleo I just installed the pads did not turn rotors just checked them for runout I didn't think about not doing those procedures could have that much of an effect on stopping.

I re-bled the brakes readjusted the rears, put in new check valve and grommet in booster, have 12lbs vaccum at idle. Brakes do work and have power assist, but not enough. It is either a weak booster or low vacuum, if I'm driving and put in neutral rev it up I have more power assist, but still...

Just installed a Mopar Electronic Ignition Coversion Kit, Is it ok to use a MSD Blaster 2 coil as long as I run a ballast resistor. Some say yes some say no. Don't want to ruin my new ECU Box !!

The booster holds vacuum, re-checked the pushrod it is right, booster Dewey said to put plugs in master cylinder ports and make sure it holds firm, doing that tomorrow, If it holds I'm stumped. I said before both master cylinders were tried and re-acted the same so I think they are both ok.

Thanks, I will do it appreciate the feedback.

Has very hard pedal with or without car running, will barely stop, doesn't feel like there is any fluid pressure at all, pedal pumps up without car running, but when started pedal goes down far and gets hard.

How never done it.

I just rebuilt my front calipers, new front pads, new master cylinder, new rear drum wheel cylinders and shoes. flushed all brake lines, took booster off cleaned it and painted it that's all, worked before I removed it. When I got it all back together bench bled cylinder, bled all brakes...

Looking for nice original E Body rear sway bar complete?

Do you have a rear sway bar E Body?

Looking for nice original rear sway bar complete.

I just signed up for this forum, anyway looking for a complete rear sway bar for my Gran Coupe

Is the rear sway bar still available?