WTB 1970 challenger needs parts

[ogre]

Hello all,

Well I finally located a shop to fix my frame and rear sheet metal of my challenger. need some parts ASAP if you have any.
1. driver side quarter panel, the top half of mine is shot, if you have one rusted on the bottom that is no good, i could use the top. of course a whole good one would be nice AMD is out or I would try their 399.00 one.

2. Frame rails for the trunk, I can get new 1/2 rails but oem full rails again out of stock at AMD. I hope I only need the short ones but I might need a driver side full.

3. In case I cant get it soon enough, an original decklid. I have one lined up but until I have it I cant count on it.

I think I have the rest for now for the rear. Thanks for looking at my post!

Ogre.

 

[DetMatt1]

I may have a quarter panel but I don’t remember what side it is, I’ll check tomorrow.

 

[ogre]

Ok Thank you,

 

[DetMatt1]

Ok Thank you,

This was drilled off at the spot welds, cut just below the flange on the C-pillar and the only thing missing is the lower rear.

 

[ogre]

That looks like everything I need and then some. I have the drip rails from AMD so it looks like they could be grafted right on. So how kind do you want to be and can it be shipped to 14127 in orchard park NY. My car's butt is in your hands!

 

[DetMatt1]

That looks like everything I need and then some. I have the drip rails from AMD so it looks like they could be grafted right on. So how kind do you want to be and can it be shipped to 14127 in orchard park NY. My car's butt is in your hands!

I’ll get some measurements for the shipping and see if I can get some quotes. Maybe you can help by getting quotes on your end too.

 

[Dutchrebuild]

I have a trunk lid...I'm 20min from orchard park ny

 

[Cuda Hunter]

Maybe find someone in Detroit that is heading to Carlisle. Have them pick the rear quarter up and deliver it to you at the parts swap meet.

 

[ogre]

This was drilled off at the spot welds, cut just below the flange on the C-pillar and the only thing missing is the lower rear.

Matt,

Here are the pics of my quarter: Like I said need the roof piece to the end and about down to the marker maybe higher to the first body line above the marker and then straight down in front of the roof.

i was hoping you would need to only cut the verticle line since the bottom was already cut below the marker.

 

[DetMatt1]

I won’t be at my shop till a bit later today. Hopefully it’s not too late for the Carlisle trip if anybody even has the room.