sixpactogo
Well-Known Member
This is a used Kelsey Hayes Cast Iron 89410 proportioning valve from a 1973 Challenger. It had been in my loft for a number of years. I decided to rebuild it so purchased the 3 kits to replace all the rubber parts and O rings. I took it apart and cleaned and polished the cylinder bores. Installed the new seals and put it back together with synthetic dot 3 fluid. It was in pretty good shape to begin with but was sticky with some gunk from years of doing it's job. I tested the switch and verified it to be working properly. I found out that it takes special O rings made from rubber that is impervious to brake fluid.
$115.00 shipped from 54703 to USA. Out of country will add to shipping fees.
$115.00 shipped from 54703 to USA. Out of country will add to shipping fees.
Last edited:
