A Few Parts WIW???

[quapman]

I'm looking to sell a few things to a European customer and have no idea what things go for these days. What are the following worth?

3.23:1 sure-grip center section-489 case (known good, used)
Rear window plug for Challenger S.E. (Just the fiberglass, no glass, no trim)
Used 70/72 Challenger front bumper brackets
E body rear sway bar w/ brackets
S.E./Gran Coupe upper console with wiring (No headliner)


Thanks

 

[KATSAAR]

shipping is goin to hurt.

 

[340challconvert]

I've seen used sure grip center sections sell between 300-500 dollars on line. 3:23 may be at the lower end of this estimate?

Factory E body sway bars with the brackets, I've seen as low as 150 and up to 250-300 dollars depending on condition.
Just my own observations: hope it helps.

If you are selling to Europe, I would check the exchange rate with the Euro, its been fluctuating

 

[challenger6pak]

Easily $750 to $900 + shipping. Where are they going? I do a lot of international shipping.

 

[quapman]

Going to France, but probably will ride along with a car I sold to the same folks.

$300 for a 3.23 s/g hog's head? Where are these and can I buy them all?

 

[340challconvert]

Going to France, but probably will ride along with a car I sold to the same folks.

$300 for a 3.23 s/g hog's head? Where are these and can I buy them all?

$300 is tough to find and they usually have issues. Have gone to swap meets and even on e-bay, on occasion, I've seen them in that price range, but it's dependent on condition. I have seen rebuilt units at a much higher price with very clean used units on the upper end of the 500 dollar scale that looked to be in good condition.
I guess if you need one in a hurry, they have you over a barrel.

If you need one and I come across a decent deal, I'll let you know.
The problem is always shipping or pick up for anything that heavy.

 

[sheetmetaldan]

Guess I scored a good deal on my 3.23 complete rear end. Bought it along with front/rear sway bars, E body factory disc brake setup & misc parts a cple years ago. I don`t think I paid over $350 for everything....... someday i`ll put it in!

 

[quapman]

I'm mostly kidding. I haven't seen a s/g center section with ANY gear ratio go for that little in many years.

 

[challenger6pak]

I see several priced around $300 at the Garlits show in Florida every year. Same for the Turkey Rod Run in Florida.

 

[AUSTA]

anything over 1 meter long gets an oversize handling fee applied
a diff center to Australia is around $185
We ship bits to texas & Miami generally find TNT freight the cheapest DHL & Fedex is over double it pays to shop around

 

[340challconvert]

anything over 1 meter long gets an oversize handling fee applied
a diff center to Australia is around $185
We ship bits to texas & Miami generally find TNT freight the cheapest DHL & Fedex is over double it pays to shop around

Good to know! There is a TNT freight office close to where I live. I had an occasion where I sold a part and had to ship to Norway. Could save a buyer some money.