SOLD Front floor pan with hump and console brackets 70-74 Cuda Challenger

[Moparparts]

FOR SALE: 71-74 Cuda Challenger front 3/4 floor pan with hump and automatic console brackets. Could also be used for 70. This is a full front pan, except for the driver's side section. It has been taken off correctly at the factory seams and spot welds, trimmed, and is ready for final prep and installation. Very good used condition, except for a small rust area on the passenger's side at the spot weld hole area where the front rail would meet the torsion bar crossmember. There is also a small rust spot, as shown in the pic, at the top outer corner of the toe pan. This does not have the inner bucket seat support brackets on the bottom side. $300 complete, as pictured. I would consider selling the right side full floor pan section and/or hump with console brackets separately. This is too large to go by ground shipping, unless the driver's side under the seat pan would be trimmed off. Could be picked up here in PA at 17086 or possibly at one of the Carlisle events. PM or post.

 

[challenger6pak]

I'll bet that took you a while to remove.

 

[Moparparts]

Floor pan

Yes it was, they are always fun especially getting it to come up off the ones along the edge of the rocker

I'll bet that took you a while to remove.

 

[Moparparts]

Bump, post or PM Carlisle delivery is possible

 

[Moparparts]

Still available pick or ship, can section. Shipping from PA 17086

 

[Moparparts]

SOLD! Thanks FEBO