islandmuscle
Active Member
looking for recommendations on the proper finish and presentation of some used sliding door wedges
these parts show some pitting on the screws and steel base area
1) what do nos originals look like?
2)is there an electro- plating type
finish on the visible area were the wedge slides? Or the whole frame work?
3)would the worn slider wedge affect door Anti-rattle ability
4)is this center slider bronze or brass or?
5) are the repo “door side“ wedges Like factory plastic covered steel?
6) is there any paint applied To the back side? Or anywere, and what type if so
any suggestions would be appreciated
and help to get a 1970 challenger convertible‘s Finishing touches worked out
these parts show some pitting on the screws and steel base area
1) what do nos originals look like?
2)is there an electro- plating type
finish on the visible area were the wedge slides? Or the whole frame work?
3)would the worn slider wedge affect door Anti-rattle ability
4)is this center slider bronze or brass or?
5) are the repo “door side“ wedges Like factory plastic covered steel?
6) is there any paint applied To the back side? Or anywere, and what type if so
any suggestions would be appreciated
and help to get a 1970 challenger convertible‘s Finishing touches worked out
