Two 70 Challengers 1 manual trans car

[FistyMopar]

Original 198 3 speed on the floor car, Deputy Model, NO A/C, MB, MS, factory Horrible Yellow. Has rust around the rear glass, trunk floor and and c-pillars, upper cowl (not lower) but it is really not as bad as most cars. 4 wheel drum. Car is pretty complete. Peanut rearend. Now has 225 with Clifford 4bbl, 318 valves in worked over head and Isky cam and dual dump headers as well as electronic ignition. I will also install the #s matching 198 motor (DNR) if the hot SS is not desired, price will be a little less. Clutch is stretched 10.5 inch, needs brake work and $$. Wheels do not go with! Make offer, be reasonable.
678 363 9318
SEE PIX HERE AND SEE IT RUN
I will get more pix shortly
http://s297.photobucket.com/albums/mm213/fistymopar/Projects%20and%20For%20Sale/Her%2070%20challenger/

The second car is a very straight 70 SS auto car, NM/NTwith much less rust than the first car, needs trunk floor and tail panel replaced and a few small patches. Peanut rearend, with 8 3/4 available. If not purchased I will soda blast and install my dynoed 426 and 4 speed in this car, or can build to suit. (I do nut and bolt restos, with plenty of references.) Factory red car, sorry no pix yet. (I know, shoot me) Most everything intact minus seats. 6,000 OBO

See My latest work here, almost done.
http://s297.photobucket.com/albums/mm213/fistymopar/Fistys Work/70 340 4-speed Cuda/
And previous cars here
http://s297.photobucket.com/home/fistymopar/allalbums

 

[FistyMopar]

Location

Cars are located in Dallas Ga, Sorry

 

[FistyMopar]

Link to the second car.....Make offer

http://s297.photobucket.com/albums/...s and For Sale/70 Challenger S6 FOR SALE/

and here is some of my work....any one need a body in white?
http://s297.photobucket.com/home/fistymopar/allalbums