• Welcome to For E Bodies Only !

    We are a community of Plymouth Cuda and Dodge Challenger owners. Join now! Its Free!

318 - best oil, transmission, radiator, brake fluids?? Getting ready to fire it up

Xcudame

Well-Known Member
Joined
May 27, 2023
Messages
1,618
Reaction score
1,215
Location
Southeast Arizona
Run the engine and transmission in neutral for about 60 seconds then check the level. The convertor won't fill in Park unless you've installed a Trans pack 2 or 3 shift kit with the special manual shift valve. This is one of the reasons I always use a deep transmission pan and extended pickup. More fluid is always a good thing.
 

gran coupe john

Well-Known Member
Joined
Aug 15, 2023
Messages
384
Reaction score
88
Location
Ohio
It is all original tranny nothing special. Thanks for your information. This will save me in the long run.
 

Ronbo73

Well-Known Member
Joined
May 27, 2021
Messages
135
Reaction score
48
Location
Dudley, MA
@Xcudame Have you been using the DOT5 brake fluid in your car? Do your brakes work well? I have been reading up on DOT5 and I have read that the braking in the car may become spongy and more susceptible to brake fade. I don't plan or road racing my car so I don't think brake fade will occur but don't want the brakes to not work well. What's you thoughts?
 

gran coupe john

Well-Known Member
Joined
Aug 15, 2023
Messages
384
Reaction score
88
Location
Ohio
@Xcudame Have you been using the DOT5 brake fluid in your car? Do your brakes work well? I have been reading up on DOT5 and I have read that the braking in the car may become spongy and more susceptible to brake fade. I don't plan or road racing my car so I don't think brake fade will occur but don't want the brakes to not work well. What's you thoughts?
I have not put any fluids in yet. I am using the original master cylinder. Probably will stay with dot 3, because that is what is recommended.
 

mrmopar340

Well-Known Member
Joined
Dec 10, 2023
Messages
411
Reaction score
257
Location
Shawsville Virginia
If your running a flat tappet camshaft be sure to use a break in oil with plenty of zinc. Also make sure it fires quickly even if you have to use some starting fluid. Fill the carb fuel bowl as well before cranking. If you have new headers break it in with an old set or they may discolor due to initial fire heat.
 
Last edited:

Challenger RTA

Well-Known Member
Joined
Oct 28, 2018
Messages
3,347
Reaction score
1,775
Location
PA Flood city
Here is a link on transmission information.
 

Xcudame

Well-Known Member
Joined
May 27, 2023
Messages
1,618
Reaction score
1,215
Location
Southeast Arizona
I've had Dot 5 brake fluid in my Challenger for about 20 years now and thousands of miles. Zero problems. In fact I think I added a little (couple ounces) last time I replaced the front disc pads. Seems like Dot 3 "disappears" more over time than Dot 5.
 

Ronbo73

Well-Known Member
Joined
May 27, 2021
Messages
135
Reaction score
48
Location
Dudley, MA
@Xcudame That's great news. Thank you for the information. It makes things easier when you know people have used products and give honest answers.
 
Back
Top