Is that a 8 3/4?

[Mopewbie]

Trying to find out which diff is this one? Any guess?

All the references I find for 8 3/4s shows no screws on the back plate.

I need to buy the gasket and driveshaft seal.

Thank you.

 

[rklein71]

no, 8 3/4 pictured below.

 

[Mopars & Missiles]

 

[Xcudame]

My guess would be an 8 1/4 as they were used on some 318 and slant six E-Bodies. Definitely not an 8 3/4 and looks too small to be a Dana 60.

 

[Mopars & Missiles]

Almost impossible to tell from the poor angle of the photos, but it looks as though the top of the rear is rounded and the bottom has a flat area on it. I'll wager 7 1/4.


Of course, it would also have helped to know what make, model, year this is in.