Location of Vinyl top trim holes

[71 shaker]

Hi Norway calling.
Thank you all for a greate forum.
I Wonder if some one can tell me the distance from the window opening to the center of the holes in the "dutch" plate. I have made them all befor painting based on mockup, but now they Seems to be to close to the Rear window.....
Any one got som pics or mesurement?
Arne

 

[Adam]

Have you placed the trim (without clips) on the car to judge the fit? The trim on the 1/4s is placed along the transition where the c-pillar meets the top of the 1/4s, then the piece on the Dutchman panel naturally falls where it needs to be; approx an inch or so below the rear window.

 

[MarksMopar1]

Hi, I have just taken the vinyl roof off my car to install a new one and clean up everything under the old "rag".
I can take a few pictures and measurements ... IM me if you like....

 

[71 shaker]

Hi.
Some pics had Been nice. Would be fine if you could post them here for every one.
Thank you.
Arne

 

[MarksMopar1]

Hi, Ok.
Took some measurements and pictures. Not as easy as it looks, these holes are for the most part in different locations. A drew out on paper the measurements as well. Let me know if you need anything else? 14 holes in total, 3 on each sail panel and 8 across the Dutchman panel. I hope the pictures and the diagram make sense.

 

[MarksMopar1]

More pictures...some maybe repeats....took what I could..

 

[71 shaker]

Thank you for Great pics. This was very important info for me. Sure many other Mopar people means the same.
Thanks again

 

[MarksMopar1]

Thank you for Great pics. This was very important info for me. Sure many other Mopar people means the same.
Thanks again

71 Shaker...your very welcome. I should have also mentioned that the holes are 1/4 drilled holes.
Should you need anything else regarding these holes just ask! Good luck on the project!