Newbie....

[moparmaster]

Hello all. I have a '73 Challenger that is being finished up. I have had it since 2010 and it has been in a shop off and on over the years. It has the original 318 that has been rebuilt with 10.5:1 compression and MSD EFI. It has Vintage Air and nearly an all new body. Hotchkis suspension, headers, sub frame connectors, dual exhaust (X pipe), 335 rear tires, etc.

I need some parts such as a used wiring harness to take the connector bodies from, center dash vents for the a/c, the panel dimmer switch, brake swit

 

[Chryco Psycho]

Welcome to the site from Panama!

 

[NoCar340]

We're glad you're here. Welcome!

 

[fasjac]

Welcome to the site from Arkansas! Sounds like a very nice ride. We would like to see some pics when you get time. Glad you’re here.

 

[Rapidfire]

Welcome to FEBO Moparmaster! Greetings from the Cornhusker state! How about some pics of your 73 Challenger! Nice to see you on the forum!

 

[moparmaster]

Ahh what the heck. Here’s a few pics.

 

[340challconvert]

moparmaster
to FEBO from New Jersey
Glad you signed on!

 

[DetMatt1]

Welcome to the site from the Motor City!

 

[moparleo]

aboard. So you put a Magnum top end on a 318 short block ?
Don't skimp now. New connectors are available and won't be brittle or cracked. Hydro-boost, nice.
Packard 56 Series Connectors & Terminals

 

[moparmaster]

aboard. So you put a Magnum top end on a 318 short block ?
Don't skimp now. New connectors are available and won't be brittle or cracked. Hydro-boost, nice.
Packard 56 Series Connectors & Terminals

I will get the connectors and only use the old harness connectors where needed. Thanks!

 

[moparmaster]

I will get the connectors and only use the old harness connectors where needed. Thanks!

Yes I did put the Iron Ram Magnum heads on the old LA motor. I built the motor before getting into the body, etc. This was before someone performed the first 5.7 swap. Looking back I should have waited and gone with a 6.1 HEMI.

 

[moparmaster]

Painted! Original EW1 (white) and matte gun metal on the side stripe and hood. Came out very nice. Final assembly pends for being able to finally drive it.

 

[Challenger RTA]

Welcome to FEBO.

 

[Mopar Nut]

 

[fk5aar]

Nice work! Welcome

 

[6PKRTSE]

Looking good.

 

[moparmaster]

Finally at a show.

 

[Cuda U Code]

nice looking Challenger, stance, color and stripes all look great