If you buy one of these E-bodies for cheap, just know the parts are not. That is the common mistake people make. If you are not performing the work yourself, the parts and labor will get you underwater very fast.
Sew Cal Rods in Ontario CA started to 3D print my floor console frame. (1st section of 3 in the picture) They digitally scanned the interior of the Cuda for designing the console. I cant wait to see it finished with the installation of the 11" screen for the Stereo/GPS, midrange and tweeter...
At this years Spring, I won 1st E-modified, and Best of show Modified....but have done lots since. Power windows, 3d printed floor console housing the window switches, push to start, backup camera, GPS/Stereo tablet, cup holders etc. Also custom B5 material on door panels and 3d printed Black...
Do you have a momentary switch push to start button? if not, you will need one. take the signal wire ( yellow ) from the harness and then out to the starter. Make sure you are NOT using the fctory starter relay that mounts to the inner fender, you must use the signal wire from the ECM harness
I...
I am a simple mind I guess, but just for the worls of me cannot figure out the ingnition wiring for the IDIDIT tilt column. If anyone has used hte ignition relay please let me know how to wire it up in simple terms. The turn signals are straight forward, but the ignition side has me pulling my...
Steve, Are you asking about the under dash part? I believe i have one but willneed to look inthe shed tomorrow. Send me a pic of what you need please to make sure
Ok, Hope everyone had an amazing summer. Wanted to update all on my restomod build. 💲💲💲. I just finshed putting the Wilwood 6 piston brakes on the front. Wow what a difference. Also wrapped up the Vintage air system, very nice product BTW..just finished the Nu-relic power window conversion and...
Thanks for the reply but as I mentioned, I’m looking for 70 only parts. Thank you though your parts while they’re good parts are not the right year for me.