AAR Hood to Radiator support seal

[Tom's EK2]

I've seen some AAR's with the rubber hood seal and some without. I had to repair my fiberglass hood, so I don't have any holes in the front to mount this seal. What is the correct mounting and thoughts on if they came with this.
THANKS

 

[don selleck]

i have a pretty original FC7 it has that installed still, not 100% sure on that I'm sure someone here has one that is more documented than mine, and can verify. I can measure holes in the next couple days if necessary.

 

[Tom's EK2]

That'll work!
Thank You

 

[don selleck]

That'll work!
Thank You

measurements are taken from left side of hood seal lays in channel except the 2 lower attachments, which are 6" from either side.

 

[don selleck]

the lower attchments are actually upper on the other side of the other 7, but I think you should be good, centered and laying in the channel

 

[Tom's EK2]

the lower attchments are actually upper on the other side of the other 7, but I think you should be good, centered and laying in the channel

Excellent!
Could you give me one picture showing precisely where the seal lays/fastened to the hood?